SmartRTSPQuick answer
Match the camera’s MAC address in your DHCP server’s leases, or use the official CP PLUS discovery tool supported by its series. CP PLUS publishes IP Finder resources, but product families differ. Confirm the actual camera address and model capabilities before adding an RTSP or ONVIF connection.
Identify the product family before choosing a tool
CP PLUS sells multiple camera and recorder families. Start with the full model number and the product’s own support page. An IP network camera, an analog camera connected to a DVR and a consumer camera managed by an app do not necessarily share the same discovery or streaming workflow.
CP PLUS describes IP Finder as a LAN camera search and configuration tool in its Orange Series downloads, and supported product specifications can identify a device search tool. This does not guarantee that one installer supports every CP PLUS product. Download the tool listed for your series from an official resource instead of assuming another manufacturer’s utility is interchangeable.
Discover and verify the local device
A DHCP client list is a useful first check on any platform. Compare the camera label’s MAC address with the lease record, because names can be generic. For tool-based discovery, use an authorized computer on the camera’s intended local network and follow the series documentation.
Steps
- Confirm the camera model, power requirement and actual cable path. Note whether it connects to the LAN or a recorder’s dedicated camera port.
- Check DHCP leases for its MAC address, or run the supported CP PLUS IP Finder or series-specific discovery tool.
- Match the device’s identity and record the current IP. Open the supported camera interface and complete authorized first-use setup if required.
- If an address change is needed, coordinate a unique static address or DHCP reservation and verify the result before updating a viewer.
Do not infer streaming support from the address
Factory addresses are model- and firmware-dependent, not universal. DHCP can assign a different current address, while a previous owner or installer may have configured static settings. Use the discovered current address and model manual instead of treating a default-IP list as evidence of your camera’s location.
A reachable management page does not prove that the product exposes an RTSP stream or ONVIF service. Check those capabilities for the exact model and firmware, including any separate camera account setup. Analog cameras normally need the recorder’s supported channel stream rather than a camera IP. Once a documented stream is ready, add it to SmartRTSP and test playback. The discovery utility handles device setup; the viewer handles the supported media connection.
Frequently asked questions
Can I use one default IP for all CP PLUS cameras?
No. Product families, firmware, DHCP and previous settings differ. Locate the actual device and check its specific manual.
Why does my DVR have an IP but its analog camera does not?
An analog camera sends video to the DVR rather than acting as an independent IP device. Use the DVR’s documented network and channel configuration.
Will every CP PLUS consumer camera work through RTSP?
Do not assume that. Verify local RTSP or ONVIF support for the exact model and firmware; an app connection alone does not establish those capabilities.