SmartRTSPQuick answer
Check your router’s DHCP leases and match the camera’s MAC address, or discover it with Hikvision’s supported local tool. SADP is familiar, but Hikvision now recommends HiTools Delivery. Use the discovered current address rather than assuming one factory IP applies to every camera.
Start with the camera’s identity and connection
Read the full model and MAC address from the camera label or installation record. A router may list a generic device name, so matching the hardware address is more reliable than guessing which client is the camera. If the camera is receiving DHCP service, the lease table can reveal its current local address.
Trace the cable before searching. A camera on a normal LAN switch and a camera connected directly to an NVR’s PoE port may belong to different networks. The recorder’s channel list can contain a camera address that your phone cannot reach directly. Follow the NVR manual for supported camera access instead of assuming that every visible recorder channel is also a LAN device.
Use official discovery and confirm the result
Hikvision’s tools should run on the required local physical network segment. Its current tool listing recommends HiTools Delivery and says SADP no longer receives updates from April 2026. Choose a supported official version for your computer and device.
Steps
- Check camera power and link indicators, then connect the computer to the camera’s intended local segment.
- Run the supported Hikvision discovery tool and refresh the list after startup.
- Match the serial number or MAC address, and note the current IP address, subnet and activation state.
- If activation is required, follow the official process. Open the confirmed address and verify that the browser identifies the expected camera.
Avoid confusing factory and assigned addresses
A common factory example is 192.168.1.64, and Hikvision’s older firmware documentation also lists a different address. Factory behavior is model- and firmware-dependent, not universal. DHCP assignment or an installer’s static settings can make the current address completely different. Do not reset a functioning camera just because it is absent at a familiar number.
After finding it, record the relationship between location, MAC address and IP. A DHCP reservation can make future discovery easier when supported by your network. If you choose a static address, coordinate an unused address with the network administrator. Finally configure the camera’s supported stream and add it to SmartRTSP. Address discovery establishes where the device is; it does not establish RTSP credentials, stream paths or control support.
Frequently asked questions
Is every Hikvision camera at 192.168.1.64?
No. Model, firmware, DHCP and previous configuration affect the current address. Confirm it through discovery or the DHCP lease table.
Why does the NVR show the camera but my phone cannot find it?
The recorder may power cameras on a separate internal network. Use the documented recorder access or channel streaming method for that installation.
Can I discover an IP without knowing the password?
A supported discovery tool may show device identity and an address, but viewing video and changing protected settings still require authorized credentials.